Under Stair Lighting
This is the board for the under stair lighting. The Atmega328 is used to read digital pins connected to photo-transistors that are being illuminated by a laser. In the event that the laser is broken the output of the shift registers will be used to trigger the base of the transistors.
Each transistor has a 10 ohm current limiting resistor. the capacitor / resistor pair that is in parallel with each transistor is used to provide a fading effect. The value of these can be changed to adjust the amount of time it takes for the LED’s to fade out.
4 comments
Leave a Reply
You must be logged in to post a comment.
hello … I am very interesting with this project, it is possible for you to share the PDE file (arduino code) or maybe ATMEGA8 and Atmega328 HEX code ?
Thanks in advance and for the help.
Kind regards,
Dedy
hello … I am very interesting with this project, and ATMEGA8 and Atmega328 HEX code .
How I get them
hello … I am very interesting with this project, it is possible for you to share the PDE file (arduino code) or maybe ATMEGA8 and Atmega328 HEX code ?
Thanks
Gurjinder